- #Setting up freepbx tutorial pdf code
- #Setting up freepbx tutorial pdf password
- #Setting up freepbx tutorial pdf plus
The last thing you need to configure is the r egistration string so that the servers know where to send your inbound calls. You do not need to change anything in the User Context and User Details fields. (But if you happen to be setting this up in a raw Asterisk install, then you will want the latter). FreePBX will automatically convert this to: insecure=port,invite on Asterisk 1.4 and higher versions. For those of you on the extremely techie side, the setting of insecure=very is correct inside FreePBX.
If you are not doing any port forwarding, this keeps the NAT pinhole open. The setting of qualify=yes is technically not needed, but it allows you to monitor the health of the internet connection in Asterisk.
#Setting up freepbx tutorial pdf password
Note: this is used as the trunk context within Asterisk. Trunk Name: Give this trunk a unique name.Right now we are going to walk through setting up. You can use either of them, or both, for outbound calling. There are two SIP Trunk Servers available on this service: and. Next you must configure the Outgoing Settings to talk to the SIPStation service.
#Setting up freepbx tutorial pdf code
#Setting up freepbx tutorial pdf plus
When finished, you will need to create a second SIP trunk for for redundancy. The following instructions will help you set up a SIP trunk for. Your SIP username and password are shown.